What should I pay attention to when waxing marble floors?

1. Choose sunny weather waxing

When the humidity is too high in rainy days, waxing will cause white turbidity. When the room temperature is below 5 degrees, the floor wax will become hard. Do not use a chemical-containing cloth to wipe the floor before waxing, which may result in poor adhesion of the floor wax.

2. Remove rubbish and dirt from the floor surface.

Use a vacuum cleaner to remove dirt and dust from the floor surface. Wipe the stains on the floor with a diluted neutral detergent and wipe with a water that is difficult to remove. To prevent the detergent from accumulating in the grooves, the rag soaked with detergent should be wrung out as much as possible. Floor wax removers can cause visible stains and bulging on the floor and should never be used.

3. Wipe with a wrung rag.

Wipe the floor surface, especially the grooved part, with a wrung rag. Carefully wipe it off and do not leave any detergent. Residual detergents and moisture can cause whitening and swelling of the surface.

4. Dry thoroughly

The moisture on the floor surface and the groove is completely dry before waxing. The time required varies depending on the season, but it takes about half a day. If it is not fully dried, the floor wax will not adhere to the surface of the floor, which will affect the appearance and cause whitening.

5. Waxing method

Shake the container with the floor wax and fully Stir well. Before the entire floor of the room is waxed, perform a partial trial at the corner of the room, etc., to confirm whether there is any abnormality. In order to prevent the floor wax from polluting the wall skirting and furniture, cover the above parts with tape paper, etc., use a clean rag to fully dip the floor wax, so as not to drip, do not pour the floor wax directly on the floor, otherwise it will Produces traces and wraps. Carefully apply according to the grain direction of the floor. Do not leak or thick or uneven. If the amount of application is too small, it will cause unevenness. Too much will result in poor film formation. Keeping thin and even is the key to waxing. Do not dilute the floor wax with water. .

6. Do not walk on the floor before drying the floor wax.

Drying usually takes 20 minutes to 1 hour. If there is a leak, it needs to be applied. If the method of waxing is used twice, the second application should be carried out after the first complete drying. Once every 6 months, you can keep the floor beautifully for a long time.

When you wax the marble floor, you should also pay attention to some matters to avoid future troubles.



Relevant recommended products

New PPR Pipes Fittings for Hot and Cold Water Conveyance

No-edge Raised Floor(Steel Panel) good quality

Low Temperature Resistant Leather Cryogenic Gloves Low temperature

Refractory Ceramic Fiber Board for Steam Pipe Insulation Made In China

Bus Ribbon -Manual Welding,-0.4*8m

Leave a Reply

Your email address will not be published. Required fields are marked *